BASIC/FlashBASIC Debugger

The BASIC/FlashBASIC debugger facilitates the debugging of new BASIC or FlashBASIC programs and the maintenance of existing BASIC or FlashBASIC programs.

The BASIC/FlashBASIC debugger has the following general capabilities:

• Step through execution of programs in single or multiple steps (see e Command).

• Transfer to a specified line number (see g Command).

• Break execution (temporarily halt) at given line numbers or when specified conditions have been satisfied (see b Command).

• Display or change any variables, including dimensioned variables (see / Command).

• Trace variables (see t Command).

• Enter the system debugger (see de Command and debug Command).

• Direct output to either terminal or printer (see lp Command).

• Display or pop GOSUB stack (see r Command).

• Display source code lines (see l Command and c Command).

The following topics are presented:

Symbol Table

Entering the Debugger

Referencing Variables

Zone Output Specification

FlashBASIC Debugger Commands